Replacement radio (RF) remote control fully compatible with the type ERREKA IRIS IR2/IR4 433,92 MHz.

The remote control has been specially developed for the following ERREKA models: DNS424 (DINGO), ER200C (ERGOS), RIS1000EC (RINO), RIS1000EIC (RINO), RIS600EC (RINO). (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)

This remote control is available on branded remote control General GATE (shown on the left). We guarantee that the remote control will perform all the functions of the original RC.

• The RF remote control General GATE fully replaces the original remote control.
• Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
• Remote control works with both fixed and rolling codes.
• Multifrequency auto-scan remote control.
• Copying/cloning of the code/protocol from the original remote control.
• Battery Panasonic CR2032 included.
• Dimensions: 69 x 34 x 10 mm
• If any specific colour required, state this information to the customers’ note during placing an order.

Copying code from the original remote control:

1. Press and hold button 1 on the General GATE remote, then press button 2 four times.
2. Release both buttons. The blue indicator LED on the General GATE remote will briefly blink every two seconds.
3. Place the original remote control you want to duplicate in front of or next to the General GATE remote.
4. On the original remote control, press and hold the button you want to duplicate. Keep the button on the original remote pressed until the blue LED on the General GATE doesn't light up. Then release the button on the original remote.
5. In a moment, the blue indicator LED on the General GATE will blink twice every two seconds. This alert informs the user that sending an additional signal is necessary for successful duplication.
6. Prepare the original remote control, create an electrical bridge between pins 1 and 5 of the 5-way connector - the remote control will light up continuously. Place it back next to the General GATE remote.
7. Once the LED on the GENERAL GATE rapidly blinks, press the button on it where you want to store the copied code, the LED will light up and then turn off after a while.
8. Remove the connecting piece - the original remote control will turn off.
9. Now you need to pair the remote control with the drive unit.

How to REGISTER the new remote control into the original main unit:

1. Enable programming mode on the receiver (refer to the receiver's user manual).
2. Press the Start button on the transmitter to save to memory. If programming is done correctly, the receiver will beep twice.
3. Once all controls are saved to memory, turn off the receiver's programming mode.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.