Replacement radio (RF) remote control fully compatible with the type HÖRMANN HSM2, HSM4 433,92 MHz.

The remote control has been specially developed for the following HÖRMANN models: HS2 433, HS4 433, HSE2 433, HSE4 433, HSM2 433, HSM4 433. (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)

This remote control is available on branded remote control General GATE (shown on the left). We guarantee that the remote control will perform all the functions of the original RC.

• The RF remote control General GATE fully replaces the original remote control.
• Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
• Remote control works with both fixed and rolling codes.
• Multifrequency auto-scan remote control.
• Copying/cloning of the code/protocol from the original remote control.
• Battery Panasonic CR2032 included.
• Dimensions: 69 x 34 x 10 mm
• If any specific colour required, state this information to the customers’ note during placing an order.

Copying code from the original remote control:

1. Press and hold button 1 on the General GATE remote and then press button 2 four times.
2. Release both buttons. The blue indicator LED on the General GATE remote will briefly blink every two seconds.
3. Place the original remote control you want to duplicate in front of or next to the General GATE remote.
4. On the original remote control, press and hold the button you want to duplicate. Keep the button on the original remote pressed until the red indicator LED on the General GATE remote rapidly flashes.
5. At this moment, press the button where you want to store the code. The red LED on the remote will briefly light up and then turn off. This confirms the correct storage of the code on the selected button.
6. The copy has been successfully created. The remote control is ready for IMMEDIATE use.

How to REGISTER the new remote control into the original main unit:

1. Short press the programming button "P" on the control unit - the red LED starts flashing slowly.
2. Press for at least 1 second the button you want to program on the new remote control - distance 1 meter between the transmitter and the receiver.
3. When successful, the red LED on the PJ flashes faster - release the remote control button.
4. As soon as the red LED stops blinking, receiving unit is ready for operation - test the remote control.

Note: Be careful with the color keys of the original HÖRMANN remote control. Each color of the HÖRMANN remote control buttons has a different frequency. Blue 868 MHz; Orange 433 MHz; Gray 40.685 MHz; Green 26,975 MHz.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.